Recipe Finder. Enter Film and Developer to compare. Use Recipe Finder to quickly compare development times for a film and developer combination. Enter " film in developer " into the search box to see results. Eg, hp5 in rodinal or tri-x in hc-110. Note: Stand developed and recipes without photos are excluded.

22/05/  · Mix the Rodinal concentration with 290 ml of tap water for 35mm, 380 ml for 127 and 500 ml for 120 add 1 part Rodinal for 150 parts water—so that’s 1.9ml for 35mm, 2.5ml for

The more common approach is ‘ Rodinal stand development ‘ for a duration of one hour. I have already written one post on stand developing (link below) but as I like to experiment I am

Rodinal stand development: light fuse and get away Patented in 1891, Rodinal is one of the oldest film developers in the world. Formerly manufactured by now-defunct Agfa, it's still produced by Agfa's remnant company in Europe, Adox, under the name R09. Despite its impressive age this developer still has a lot going for it.

So, I bought a bottle of Rodinal, which would work well for stand development - as well as apparently not going bad in a couple of years.

HP5 in Rodinal 1+75 -- ISO 200 (20)C 16 min (24)C 10 1/4 min

The development times are given for negatives printed in condenser enlargers with normal average scene brightness on grades 2 and 3 paper. The data assumes processing in a spiral tank with agitation for the first 10 seconds of development and then for 10 seconds every

Rodinal stand development problem. 2 months ago FIlm: HP5+ ISO: 1600 Developer : Rodinal 1+100 Time: 120 minutes Agitation:Only first minute. Problem: One side is darker that other

3- Ilford ILFOTEC DD-X- Dillution : 1+9 - Developing time : 45 min (Stand development) 4- Rodinal R09 - Dilution 1+100 - Developing time : 45 min (Stand development) All settings on camera were of course identical on each frames and I tried to shot them as quickly as possible so I could maintain a constant exposure throughout the roll

First one is Rodinal (Adox Adonal) with Ilford HP5+ I shot a roll of HP5 at box speed and then stand developed it in Adonal for 80 mins with minimal 

Film Developer Dilution ASA/ISO 35mm 120 Sheet Temp Notes; Adox CHS 100: Rodinal: 1+50: 50: 9: 9: 9: 20C: Adox CHS 100: Rodinal: 1+25: 80: 5: 5: 5: 20C: Adox CHS 100

So I'm thinking about giving stand developing a go with the above film and developer. I looked up the massive dev chart and found a mixture 

25/02/  · I am attempting to standardize 4x5 film processing using stand development. I like my Jobo 3010 for evenness, but I like stand for tone. I am using a Yankee tank, developing 6 sheets of film at a time. I expose the film at ISO50 and use a dilution of 1:100 for N, N-1 is 1:200, N-2 is 1:400 etc. The tones are great but I am getting staining around the edges.

I (semi) stand develop Kentmere 400 shot at 6400 in Rodinal, if I remember I use 1:40 as my dilution for 1 hour. I do 30s or 60s initial 

I use 3,5 ml of Rodinal pr roll of 35mm film no matter if I have one, two or several film in the tank. I dilute it with the amount of water that is necessary 

27/05/  · rodinal-stand id11-stock 2-bath pyro THE MORTENSEN METHOD. Dilute ID11 stock at 1+3. Get the temperature to 20ºC. Pour into the tank, start clock and agitate for 30 seconds. Agitate three gentle inversions each 30 seconds for the first ten minutes. Leave standing, untouched for 50 minutes. Agitate every minute for the next ten minutes.

HP5 in Rodinal gets a bad rep - this was pushed to 1600 too, and the grain You achieved better results than I've managed in Rodinal! Stand developed?

The details are. Rodinal 1+200, presoaked for 5 mins, room temperature (!), 30secs initial. agitation and left for 2hrs, shot at 400. This was my first time stand developing and there was a gradient of density. across the height of the negative. Looked like uneven development. The 120 was. way worse than the 135.

Usually with a push development you get very increased contrast, stand development with a weak developer avoids this. 60 minutes stand in Rodinal 1:100 at 20 °C is a good starting point. Most films will give usable results. If you like it depends on your taste. The slower the film, the less time you need.

I know Rodinal is the most used developer used for stand developing, and I have have that readily available. Yet, I don't like using it for 

This is HP5 stand developed in the fridge for 1 hour, Rodinal 1+100 starting at 17 degrees then put in the fridge and left. Hello guest!

EI 3200/36 and given extended development in ILFORD ILFOTEC DD-X, ILFOTEC HC, MICROPHEN or ILFOTEC RT RAPID developers. HP5 Plus 35mm film is coated on 0.125mm/5-mil acetate base and is available in 24 or 36 exposure cassettes, or in bulk lengths of 30.5 metres (100ft). Agfa Rodinal 1+25 − − − 6 8 − −